GPS technology
Type, channels
L1 measurements
L2 measurements |
SmartTrack
Dual frequency, 12 L1 + 12 L2, 20 Hz
Carrier phase full wave length, C/A narrow code.
Carrier phase full wave length, AS off or on P2 code / P-code aided under AS.
Equal performance with AS off or on.
|
SmartTrack
Advanced GPS
measurement technology |
Time to acquire all satellites after switching on: typically 30 sec.
Re-acquisition after loss of lock: typically within 1 sec.
High sensitivity: acquires more than 99 % of possible observations above 10 degrees elevation. Low signal noise. Robust
tracking. Tracks weak signals to low elevations. Multipath mitigation. Jamming resistant.
|
Measurement
precision
Carrier phase
Code (pseudorange) |
L1: 0.2 mm rms L2: 0.2 mm rms
L1: 20 mm rms L2: 20 mm rms
|
| Status LEDs |
Power, tracking, traffic on serial ports
|
| Control software (required) |
Leica GPS Spider. For managing single and multiple receivers, for computing positions, and for creating RINEX files for post-processing.
|
| Data output |
Leica binary (LB2) raw data, independent for each serial port
|
| Weight |
0.8 kg
|
| Size (L x W x D) |
16.7 cm x 12.3 cm x 4.0 cm
|
Temperature range
Operating
Storage |
ISO9022, MIL-STD-810F
-40° C to +65° C
-40° C to +80° C
|
Humidity
Rain, dust, sand, wind |
Up to 95%
IP67 – Protection against blowing rain and dust
Waterproof to temporary submersion into water (1 m)
|
| Vibration |
10 Hz - 500 Hz, 0.7 mm, 5 g
|
| Bump |
25 g, 6 ms
|
Supply voltage
External power input
Power ports |
Nominal 12 V DC
10.5 V to 28 V DC
2
|
| Power consumption |
2.4 W, sleep mode 0.007 W
|
Ports
External Power
Serial
Antenna
PPS output |
1 LEMO connector with 2 power inputs (y-cable)
2 LEMO-1 connectors, 8-pin, 4800 - 115’200 baud
1 TNC
1 LEMO HGP.0S.250.CTL
|
| Recommended antenna |
Leica AX1202, Leica AT504
|
